Passive scrubber with flow rate up to 30 m³/hour







- Article code
- 42.1.6.102
- Description
- Passive scrubber with flow rate up to 30 m³/hour
- Inner dimensions
- Ø990 mm x H 1000 mm
- Outer dimensions
- Building height: approx. 1700 mm (incl. connections)
- Total height
- 1700 mm
- Colour
- black
- Material
- HDPE
- More information
- For water-based neutralization of exhaust gases in storage tanks with filling rates up to 30m³/h. This scrubber can be used for HCl, acetic acid, ...
- Round tank, flat bottom, closed design and conical roof.
- Calculated for continuous operation.
Connections:
- Empty Ø32 with ball valve and flange (at the bottom of the tank). This should be done on a regular basis so that the water does not become saturated. The wastewater should be processed subsequently.
- Sounding glass made of transparent PVC.
- Overflow pipe Ø32 on the same connection as the outlet. This must always be free and may not be closed with a blind flange.
- Water filling pipe Ø25 with loose flange
- Pipe Ø110 with flange, immersion pipe and an air distribution plate to distribute the air over the entire surface of the scrubber (supply of exhaust gases from the storage tanks). The immersed pipe is provided with holes to allow the air to escape through the water.
- Ø110 vent cap (exit of gases).
- PVC ball check valve Ø50 for ventilating the tank. If the tank is emptied by normal use, air should enter the tank to avoid negative pressure. This can be done through the check valve so that fresh ambient air enters the tank.
- Rotary cap for internal control of the washer.
- ID plate, 2x lifting eyes and anchor holes for M10 fasteners in the bottom plate
De wasser is voorzien van een vlakke bodem en kegelvormig dak.
Er zijn steeds de volgende aansluitingen:
- Leeglaat Ø32 met kogelkraan en flens (onderaan de tank)
- De lediging moet op regelmatige basis te gebeuren zodat het water niet verzadigd geraakt. Het afvalwater dient aansluitend verwerkt te worden.
- Overloopleiding Ø32 met 3-delige koppeling
- Watervulleiding Ø25 met losse flens
- Leiding Ø110 met flens, dompelbuis, interne bocht en een ondergedompelde leiding op de bodem van de tank (toevoer van uitlaatgassen van de opslagtanks). De ondergedompelde leiding is voorzien van gaatjes zodat de lucht door het water kan ontsnappen.
- Ontluchtingskap Ø110 (uitgang van de gassen)
- PVC kogelterugslagklep Ø50 voor de verluchting van de tank. Indien de tank wordt leeggemaakt door het normale gebruik, dan dient er lucht in de tank te komen om onderdruk te vermijden. Dit kan via de terugslagklep zodat er verse omgevingslucht in de tank komt.
- Draaidop voor de interne controle van de wasser
Optioneel:
- Vlotter met contacten om het waterniveau zichtbaar te maken. De contacten kunnen in combinatie met automatische kleppen ervoor zorgen dat het systeem autonoom werkt.
- De wasser kan op hoogte geplaatst worden om na het vullen de wasser automatisch gravitair leeg te laten.
- Verdere automatisatie: een pH-meting kan de wasservloeistof controleren en samen met automatische kleppen kan de vloeistof gespuid of aangevuld worden.
- Breekplaat of ventiel die de wasser beschermt tegen over- en onderdruk.